Syllabus - Automotive Design & Assembly Drawing (AU-504 (D))

Automobile Engineering

Automotive Design & Assembly Drawing (AU-504 (D))

V-Semester

Unit-1

Frame Design

Loads & Moments acting on frames, Beam theories, Deflection of beams; Concepts of CG & MI in designing and selection of frame cross sections, frame materials.

Unit-2

Cam Design

Introduction, cam terminology, types of cam, follower and follower motions. Motion constraints, single-dwell and double-dwell cam design. Critical path motion, pressure angle and radius of curvature of cam motion; introduction of SOHC and DOHC.

Unit-3

Design of Suspension Spring and Front Axle

Types of suspension system, types of suspension springs, design of leaf spring, coil spring; design of front axle beam.

Unit-4

Design of IC Engine Parts

Introduction to principle parts of an I.C engine, design of cylinder and cylinder liner, piston, connecting rod, crank shaft (calculation for bearing pressure and stresses in crank shaft); design of valves; vehicle design and data characteristics.

Unit-5

Assembly Drawings

a) Piston Assembly b) Connecting Rod Assembly c) Shackle Assembly d) Wheel Cylinder Assembly e) Master Assembly

Practicals

Reference Books

  • Timoshenko S; Strength of Materials, CBS Pub

  • Shigley J E et al; Mechanical Engineering Design, TMH Pub

  • Bhatt, N D; Machine Drawing; Charotar Pub

  • Gopal Krishna K R; Machine Drawing, Subhash Pub

  • Gupta, R B ; Automotive Engineering Drawing, Satya Pub